Introduction

Wall lights add a certain charm and elegance to a room. However, many homes in the UK come equipped with wall lights that require hardwiring. This can pose a problem if you want to move the light to a different location or if you don’t want to go through the hassle and expense of rewiring the light.

The good news is that converting a wall light to a plug is a simple DIY project that almost anyone can do. In this article, we will walk you through the steps to convert a wall light to a plug in the UK.

Materials Required

Before you begin, you will need the following materials:

• A wall light
• A plug socket
• A power cord with a plug (make sure the cord is rated for the wattage of your light)
• Screwdriver

Step-by-Step Guide

Step 1: Turn off the power

Before you begin working on the wall light, it is important to turn off the power to the circuit. Locate the circuit breaker that controls the power to the light, and flip it to the “off” position.

Step 2: Remove the wall light

Using a screwdriver, unscrew the screws that hold the wall light to the wall. Once the screws are removed, carefully pull the light away from the wall to access the wiring.

Step 3: Disconnect the wiring

Locate the wiring that connects the wall light to the electrical circuit. To disconnect the wiring, you may need to unscrew wire nuts or use a pair of wire cutters to snip the wires.

Step 4: Prepare the power cord

Cut the power cord to the appropriate length, leaving enough cord to reach the nearest outlet. Remove one inch of insulation from the ends of the wires and connect them to the appropriate wires inside the wall light using wire nuts.

Step 5: Attach the plug

Attach the plug to the opposite end of the power cord by following the manufacturer’s instructions. Make sure the plug is securely attached and that the wires are connected correctly.

Step 6: Attach the wall light to the wall

Once the wiring has been connected and the plug attached, securely attach the wall light back to the wall using the screws and screwdriver.

Step 7: Turn on the power

Finally, turn on the power to the circuit breaker and test the wall light to make sure it is working properly.

Conclusion

Converting a wall light to a plug is a simple DIY project that can save you time and money. With the right tools and materials, you can easily convert your hardwired wall light to a plug and move it to any location in your home. Remember to always turn off the power to the circuit before working on any electrical wiring, and follow the manufacturer’s instructions when attaching the plug to the power cord. Happy DIY-ing!